ADVERTISEMENT

My mother-in-law taught me this trick to get that burnt grease splatter off the inside microwave walls with 0 effort. Here’s how it works

ADVERTISEMENT

For a lightly dirty microwave, 3 minutes on high is often enough. For a microwave with visible burnt splatter on the ceiling and side walls, I usually run it 4 minutes. For a really neglected microwave, I go 5 minutes, but I keep an eye on it to make sure the water is steaming steadily and not boiling down too much.

Wattage matters. A 700-watt microwave may need closer to 5 minutes, while a 1,100-watt model may produce enough steam in 2 1/2 to 3 minutes. What you want to see is condensation collecting inside and the bowl actively steaming.

6. The most important part: let the steam sit

This is the step people skip, and it is the reason the trick sometimes gets dismissed as not working. Do not open the door the second the timer goes off. Leave it closed for 5 full minutes. In bad cases, 7 minutes is even better.

That waiting period gives the steam time to cling to the grime and rehydrate the dried-on splatter. Think of it like loosening baked food in a pan by soaking it. If you open the door too quickly, the steam escapes before it can do its job.

7. How to wipe the walls with almost no scrubbing

Once the microwave has sat, I open the door carefully because the steam can be hot. I remove the bowl using a towel or oven mitt if needed, then start at the top. Gravity matters here. If you clean the bottom first, you can drip grime onto the area you just wiped.

I use a damp microfiber cloth folded into quarters so I can switch to a clean section as I go. The ceiling usually wipes clean in one or two passes. Then I move to the side walls, the back wall, the door interior, and finally the floor of the microwave. On a typical mess, the whole wipe-down takes under 2 minutes.

8. What to do with the stubborn burnt spots

Every now and then there will be one or two spots that still cling on, usually near the vents or along the ceiling seam. For those, I dip the corner of the cloth in the hot vinegar water and press it against the spot for 10 to 15 seconds. That little bit of direct heat and moisture usually softens it enough to lift.

If that still does not work, I make a quick paste with about 1 tablespoon of baking soda and a few drops of water. I dab it onto the spot, let it sit for 2 minutes, and gently rub with a soft sponge. I avoid hard scouring pads because they can scratch the interior coating.

9. Don’t forget the turntable and roller ring

The glass turntable catches drips and often has a sticky ring of grease around the edge. I take it out and wash it in warm water with a few drops of dish soap, just like a dinner plate. If the grease is baked on, a 10-minute soak in hot soapy water usually solves it.

The roller ring underneath can get surprisingly grimy too. I wipe it with the same cloth or wash it in the sink and dry it well before putting everything back. A clean turntable keeps the whole microwave from smelling stale.

ADVERTISEMENT

See next page:

Leave a Comment